For sale is all the metal you need to make a trailer that is shown in the first two pictures. Corners are cut and the uprights are cut and so are the crossbeams so that you can basically start welding right away and make the trailer that you see in the first picture. there is no ball hitch receiver included and included is a large part of the electrical. No axle and no wheels and no fender included. It is just the frame. Included should be enough of the mesh for the sides as well as for making a 4 foot end gate. There will be some extra tubing included for this project and also the metal extras will include enough to add a dovetail to the trailer. pictures show the outside dimensions on the first two pictures. The third picture shows the height. The bottom frame is made out of 3 x 3 tubing which is 1/8 wall and the side uprights are made out of 2 x 3 3/16 wall. The top has quarter inch flat bar that goes along the top. there are also pieces cut and shaped for the endgate so that you have rounded tops and also have pins and bushings to mount on the bottom of the end gate so that it pivots nicely. I have the materials all cut to fit on a Princess Auto 6’ axle so that the springs mount to the bottom of the three by threes. Emails only to hbfehr@gmail.com.